목차
1. Introduction
2. Theoretical background
2.1 Three-point bending
2.2 Span length
2.3 Shear force and bending moment
2.4 Curvature of a beam
2.5 Bending stress
2.6 Modulus of elasticity
2.7 Bending deflection
2.8 0.2 % offset yield strength
2.9 Method of data processing
3. Procedure of test
4. Result
4.1 Load-deflection curve
4.2 Bending stress-strain curve
4.3 Shear force diagram and bending moment diagram
5. Conclusion
References
본문내용
1. Introduction
When designing a building, automobile, or aerospace, it is important to know reaction between structural members. A beam, which a bar applied loading laterally to its axis and one of the structural members, is classified as planer structures. When external load is applied to the beam, the shear force and bending moment occurs in the beam.
At this time, three-point bending test is conducted to know bending properties of Al 6061-O. Three-point bending test is to apply concentrated load on the center point of specimen that supported by pin or roller. Through this test, calculate bending stress and strain, and then draw a bending stress-strain curve, and then obtain the value of Young’s modulus and yield strength by using 0.2 % offset method. Also, calculate the shear force and bending moment, and then draw each diagrams according to location.
2. Theoretical background
2.1 Three-point bending
For bending tests, there is no involvement with ......<중 략>
참고 자료
J. M. Hodgkinson, 2000, Mechanical Testing of Advanced Fiber Composites, Woodhead Publishing limited, pp. 125.
ASTM, 2014, “Standard Test Methods for Bend Testing of Material for Ductility”, ASTM international, E290-09, pp. 2, 3.
James M. Gere and Barry J. Goodno, 2013, “Mechanics of Materials Brief Edition”, Cengage Engineering, pp. 360~391.
ASM, 2000, “Mechanical Testing and Evaluation”, ASM International, Vol. 8, pp. 87.
Ferdinand P. Beer, E. Russell Johnston, John T. Dewolf and Daid F. Mazurek, 2009, “Mechanics of Materials 5th Edition”, McGraw-Hill, pp. 595.
ASTM, 2014, “Standard Test Method for Tensile Properties of Plastics”, ASTM International, D638-14, pp. 11.
ASTM, 2010, “Standard Test Method for Young’s Modulus, Tangent Modulus, and Chord Modulus”, ASTM International, E111–04, pp. 2.
Hossein Tavakoli, 2013, “A Dictionary of Research Methodology and Statistics in Applied Linguistics”, Rahnama Press, pp. 7, 74.
ASM, 2000, “Properties and Selection Nonferrous Alloys”, ASM International Vol.2, pp 405.
Young-Ha Yeom, 1992, “The Method of Materials Experiment”, Dongmyungsa, pp. 99.