알칼리 활성화된 고로슬래그 페이스트의 물리화학적 특성 및 이산화탄소 흡수능 평가
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국도로학회
ㆍ수록지정보 : 한국도로학회논문집 / 17권 / 2호
ㆍ저자명 : 안해영, 박철우, 박희문, 송지현
ㆍ저자명 : 안해영, 박철우, 박희문, 송지현
영어 초록
PURPOSES: In this study, alkali-activated blast-furnace slag (AABFS) was investigated to determine its capacity to absorb carbon dioxide and to demonstrate the feasibility of its use as an alternative to ordinary Portland cement (OPC). In addition, this study was performed to evaluate the influence of the alkali-activator concentration on the absorption capacity and physicochemical characteristics.METHODS: To determine the characteristics of the AABFS as a function of the activator concentration, blast-furnace slag was activated by using calcium hydroxide at mass ratios ranging from 6 to 24%. The AABFS pastes were used to evaluate the carbon dioxide absorption capacity and rate, while the OPC paste was tested under the same conditions for comparison. The changes in the surface morphology and chemical composition before and after the carbon dioxide absorption were analyzed by using SEM and XRF.
RESULTS: At an activator concentration of 24%, the AABFS absorbed approximately 42g of carbon dioxide per mass of paste. Meanwhile, the amount of carbon dioxide absorbed onto the OPC was minimal at the same activator concentration, indicating that the AABFS actively absorbed carbon dioxide as a result of the carbonation reaction on its surface. However, the carbon dioxide absorption capacity and rate decreased as the activator concentration increased, because a high concentration of the activator promoted a hydration reaction and formed a dense internal structure, which was confirmed by SEM analysis. The results of the XRF analyses showed that the CaO ratio increased after the carbon dioxide absorption.
CONCLUSIONS : The experimental results confirmed that the AABFS was capable of absorbing large amounts of carbon dioxide, suggesting that it can be used as a dry absorbent for carbon capture and sequestration and as a feasible alternative to OPC. In the formation of AABFS, the activator concentration affected the hydration reaction and changed the surface and internal structure, resulting in changes to the carbon dioxide absorption capacity and rate. Accordingly, the activator ratio should be carefully selected to enhance not only the carbon capture capacity but also the physicochemical characteristics of the geopolymer.
참고 자료
없음태그
"한국도로학회논문집"의 다른 논문
- 도로 종류와 도로생애주기별 탄소배출량, 에너지소모량 및 비용에 대한 거시적 분석방법8페이지
- 주변 환경 순응형 자동차 경적 소음 개선 방법7페이지
- 다수단 Mode를 고려한 도시부 도로의 서비스수준 평가방법에 관한 기초연구12페이지
- 가상주행과 실차주행의 운전자 주행행태 차이에 관한 연구16페이지
- 아스팔트 도로포장 유지보수용 표면처리공법의 공용성 평가10페이지
- 겨울철 도시부 노면결빙사고 발생에 미치는 요소에 관한 연구9페이지
- 마이크로서페이싱의 성공과 실패 사례8페이지
- 도로유실 복구를 위한 골재 충전 고흐름도 모르타르의 기초 배합 연구8페이지
- 아스팔트 콘크리트 포장용 균열실링재의 부착특성 평가8페이지
- 광물질혼화재를 적용한 콘크리트의 스케일링 저항성 평가7페이지