GMAW 원격 제어 토치 성능에 따른 용접 부의 실험적 연구
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국기계기술학회
ㆍ수록지정보 : 한국기계기술학회지 / 16권 / 3호
ㆍ저자명 : 김정혁, 오석형, 양현수
ㆍ저자명 : 김정혁, 오석형, 양현수
목차
Abstract1. Introduction
2. Experiment Device and Method
2.1 Welding device
2.2 Materials and filler metal
2.3 Experimental method
2.4 Visual inspection on the welds
2.5 Bending test
3. Experimental Results and Consideration
3.1 Visual inspection on the spatter by the change of the welding current and voltage
3.2 Bending test of the surface with V-type butt welding
4. Conclusion
References
영어 초록
In GMAW welding used mostly at the scene of a welding industry, welders can not see control panels in internal welds of vehicles and tanks, and can not adjust the current and voltage properly during the welding, which is caused by distance from the working area. Therefore, welders have to move to control the current and voltage by stopping welding. This, however, can result in the welding defects by momentary cooling. In this research related to the existing GMAW welding methods and the manners with the remote control torch their performances were evaluated by comparing and analyzing the welds of V-type butt using SM50A 6 mm and welding structural rolled steels. As the result of conducting the visual inspection and bending test one by one against the V-type butt welds, the amount of spatter by the remote control torch method showed reducing effects about five times lower and it had a performance that did not affect the weld defects by displaying suitable effects on the bending test of welds. Consequently, the experimental study on the possibility of replacement and compatibility with the existing commercial welder for the remote control torch was performed.참고 자료
없음"한국기계기술학회지"의 다른 논문
- 파워시트용 모터들의 진동 해석에 의한 강도 내구성 연구6페이지
- 고성능 합지장치 개발5페이지
- 석재 표면가공을 위한 자동 고속버너 가공기 개발5페이지
- 승용차 시트용 하이트 모터의 기어 너트 지지 구조에서의 진동에 의한 강도 해석6페이지
- X-ray Scanning System 개발에 있어서 Line Detector 원리의 적용5페이지
- 다공성 표면복사버너에서 열특성 연구7페이지
- 타이어 트레드 강성에 따른 충격 하쉬니스에 관한 연구7페이지
- 유로의 채널 형태에 따른 연료 전지 성능에 관한 연구7페이지
- 상용차용 복합소재 서브프레임에 대한 구조시험 및 유한요소해석 평가6페이지
- 연삭가공 분진입자의 공기 중 거동 특성 분석6페이지