적산온도에 의한 FRC 기층의 강도발현 성능 분석
* 본 문서는 배포용으로 복사 및 편집이 불가합니다.
서지정보
ㆍ발행기관 : 한국도로학회
ㆍ수록지정보 : 한국도로학회논문집 / 18권 / 1호
ㆍ저자명 : 최성용, 박영환, 정우태
ㆍ저자명 : 최성용, 박영환, 정우태
목차
1. 서론2. 외기온도에 따른 콘크리트의 시공구분
3. 한랭기 및 서중 콘크리트의 강도발현 성능 검토
4. 적산온도에 의한 FRC 기층 강도발현 성능 분석
5. 기층 기준 강도 5MPa 도달시기 예측
6. 결론
감사의 글
REFERENCES
영어 초록
PURPOSES: In this study, we analyzed the compressive strength characteristics of lean base concrete in relation to changes in the outdoor temperature after analyzing the cold and hot weather temperature standards and calculated the minimum and maximum temperatures when pouring concrete. We examined the rate of strength development of lean base concrete in relation to the temperature change and derived an appropriate analysis formula for FRC base structures by assigning the accumulated strength data and existing maturity formula. METHODS: We measured the strength changes at three curing temperatures (5, 20, and 35℃) by curing the concrete in a temperature range that covered the lowest temperature of the cold period, 5℃, to the highest temperature of the hot period, 35℃. We assigned the general lean concrete and FRC as test variables. A strength test was planned to measure the strength after 3, 5, 7, 14, and 28 days. RESULTS : According to the results of compressive strength tests of plain concrete and FRC in relation to curing temperature, the plain concrete had a compressive strength greater than 5 MPa at all curing temperatures on day 5 and satisfied the lean concrete standard. In the case of FRC, because the initial strength was substantially reduced as a result of a 30% substitution of fly ash, it did not satisfy the strength standard of 5 MPa when it was cured at 5℃ on day 7. In addition, because the fly ash in the FRC caused a Pozzolanic reaction with the progress into late age, the amount of strength development increased. In the case of a curing temperature of 20℃, the FRC strength was about 66% on day 3 compared with the plain concrete, but it is increased to about 77% on day 28. In the case of a curing temperature of 35℃, the FRC strength development rate was about 63% on day 3 compared with the plain concrete, but it increased to about 88% on day 28. CONCLUSIONS: We derived a strength analysis formula using the maturity temperatures with all the strength data and presented the point in time when it reached the base concrete standard, which was 5 MPa for each air temperature. We believe that our findings could be utilized as a reference in the construction of base concrete for a site during a cold or hot weather period.참고 자료
없음"한국도로학회논문집"의 다른 논문
- 효율적인 도로정보 제공을 위한 도로표지판 개선방안 제시11페이지
- 거시적 교통류모형을 이용한 고속도로 돌발상황에 따른 탄소배출량 산정연구11페이지
- 대형로터리에서의 특수 회전교차로 운영효과9페이지
- VDS 자료 기반 고속도로 교통혼잡비용 산정 방법론 연구9페이지
- 베이지안 기법을 활용한 공용성 모델개발 연구7페이지
- 도로 램프구간에 대한 파손형태 및 원인에 관한 연구6페이지
- 연속철근 콘크리트 포장 수치해석 모델의 해석결과 정확도 개선 방법11페이지
- 롤러 전압 콘크리트 포장의 공기량 및 기포간격계수와 장기 내구성의 상관관계 분석을 위한 실험적 연구10페이지
- Overlay Tester를 이용한 그리드 보강 아스팔트 포장의 반사균열 저항성 평가6페이지
- 콘크리트 포장의 급속 보수를 위한 산화마그네슘계열 단면복구재의 성능에 대한 실험적 연구13페이지